Aluminum Alloy Sheet Punch Press

Solar aluminum alloy press machine, is a stamping press.In production, stamping process than traditional machining is more material and energy saving, high efficiency, the technical requirements of the operator is not high, and through a variety of die applications can make mechanical processing can not achieve these advantages.

Product Details

Product description

aluminum alloy press machine, It is suitable for deep processing of solar energy aluminum alloy frame, aluminum alloy door and window.

In production, stamping process than traditional machining is more material and energy saving, high efficiency, the technical requirements of the operator is not high, and through a variety of die applications can make mechanical processing can not achieve these advantages, so it is more and more widely used.

Stamping production is mainly for the plate.

Through the mold, can make blanking, punching, molding, drawing, dressing, fine punching, shaping, riveting and extrusion pieces, and so on, widely used in various fields.

zhutu

Production safety

Because the press has the characteristic of high speed and high pressure, so the use of the press for blanking and forming must abide by certain safety regulations.

1.Protective cover must be installed for transmission parts exposed outside the press. It is forbidden to start or test run without protective cover.

2.Before starting, check whether the main fastening screw is loose, whether the mold is cracked, whether the control mechanism, automatic stop device, clutch and brake are normal, and whether the lubrication system is blocked or short of oil.

You can run an empty car if necessary.

3.To install the mold, the slider must be opened to the bottom dead center, the closing height must be correct, and try to avoid eccentric load;

The mould must be firmly fastened and pressure tested.

4.Concentrate on your work. Do not put your hands, tools or other objects into the dangerous area.

Small items must be handled with special tools (tweezers or feeding mechanism).

When the die is stuck, only use the tool to free the blank.

5.If abnormal operation or abnormal sound is found in the press, (such as continuous strike sound, popping sound) the feeding shall be stopped immediately and the reason shall be checked.

If the rotating parts become loose, the control device fails, the mold becomes loose and the defect is found, the vehicle should be stopped for repair.

6.Each time a workpiece is flushed, the hand or foot must be removed from the button or pedal to prevent misoperation.

7.When more than two people operate, should drive, pay attention to coordination.

Before going off work, the mold should be placed on, disconnected from the power supply, and necessary cleaning.


详情

图片12


FAQ

1. Q:Are you a manufacturer, trading company or a third party?

A:We are a manufacturer, and we have builded up our company since 2008.

2. Q:Where is your factory located?

A:Our factory address is : No.32 Xiaying Road Qiaoqi Village Xuxiake Town Jiangyin City, Jiangsu Province, China.

3. Q:How can i get to your factory?

A:Our factory is near shanghai Airport, we can pick you up in the airport.

4. Q:If i will need to stay in your place for few days, is that possible to book the hotel for me?

A:It's always my pleasure, hotel booking service is available.


Inquiry