Home > News > Content

Plastic Shredder Pay Attention To The Operation

Sep 08, 2017

Plastic crusher is used to crush all kinds of plastic plastics and rubber such as plastic special profile, tube, rod, silk thread, film and used rubber products. The granules can be extruded directly as raw materials.

This kind of machinery USES alloy steel blade, long life; At the same time, the machinery is to separate design, easy to maintenance and cleaning, with double structure, equipped with sound insulation materials, noise is low, the knife shaft through strict balance test, and the machine base is equipped with four-wheel, mobile convenience.

Equipment use

Save time: immediately collect in 30 seconds, do not wait to be concentrated to smash, and be clean and clean. Improve the quality: the water mouth is expected to be oxidized after being taken out of the high temperature, humidification (absorb water) and damage property, and immediately recovery can reduce the physical strength in 30 seconds, reducing the damage of color luster

Save money: short time of recycling, avoid pollution, mix materials caused by the bad rate, can reduce plastic, artificial, management, storage, the waste and wastage of material purchase;

Wide application: suitable for pulverizing soft, hard material, such as PU, PVC, PC and ABC.

Simple: easy to open design, easy to change color change, small and small space, suitable for the small workshop stand next to use; Adopt medium speed motor, low noise, low energy consumption; The motor is equipped with an overload protection device, and has the power chain protection system, which is safe and reliable.

General provisions

Article 1 reprint machine, grinder drivers must go through the training, to achieve "SanDong" (understand the structure, performance, understand principle), "sihui" (to use, can maintenance, maintenance, troubleshooting), after passing the exam of the training, after obtain certificate of approval, party must mount guard operation.

Article 2 the driver and the driver of the conveyer belt conveyor are closely coordinated with the driver of the working face scraper, and the unified signal is connected in sequence and stopped. In the case of large coal and gangue, it should stop the conveyor operation of the working and face scraper when the feeding port of the mill is overflowed. If the large coal, the gangue cannot enter the broken connection or the metal object, must stop processing.

The preparatory work

1. Tools: wrenches, pliers, screwdrivers, hammers, shovels, etc.

2. Necessary spare parts: all kinds of short chain, link, bolt, nuts, crusher, etc.

3. Lubricating oil and turbine oil

Pay attention to the operation

1. The plastic crusher and power unit should be installed firmly. If a plastic crusher is needed for long-term operation, it should be fixed on cement. If you need plastic crusher, the unit shall be installed on the made of Angle iron frame, and ensure that power generator (diesel or motor) and plastic crusher pulley groove in the same rotary surface. 2. After the plastic grinder is installed, check the fastening conditions of the fasteners and tighten them if they are loose. Also check if the belt tightness is appropriate.

3, plastic crusher, before starting to turn the rotor by hand first, check the tooth claw hammer, operation is flexible and reliable, and rotor broken interior presence of collision phenomena, the direction of rotation of the rotor machine direction arrow, engine lubrication and plastic crusher are in good condition.

4. Do not change the pulley, in case the speed is too high, which causes the broken room to explode, or the speed is too low to affect the efficiency of the shredder.

5. After starting the plastic crusher, it should be kept free for 2 ~ 3min, no abnormal phenomenon and re-feeding work.

6. Pay attention to the operation of the plastic shredder at any time. First, the feeding should be even, in case of blocking the broken room; Second, don't work long hours. If the vibration, noise, bearing and body temperature are found to be too high, it should stop the inspection immediately, and can continue to work after troubleshooting.