Home > News > Content

Plastic Shredder Check Processing

Oct 17, 2017

Plastic crusher is used to crush all kinds of plastic plastics and rubber such as plastic special profile, tube, rod, silk thread, film and used rubber products. The granules can be extruded directly as raw materials.

This kind of machinery USES alloy steel blade, long life; At the same time, the machinery is to separate design, easy to maintenance and cleaning, with double structure, equipped with sound insulation materials, noise is low, the knife shaft through strict balance test, and the machine base is equipped with four-wheel, mobile convenience.

Equipment use

Save time: immediately collect in 30 seconds, do not wait to be concentrated to smash, and be clean and clean.

Improve the quality: the water mouth is expected to be oxidized after being taken out of the high temperature, humidification (absorb water) and damage property, and immediately recovery can reduce the physical strength in 30 seconds, reducing the damage of color luster

Save money: short time of recycling, avoid pollution, mix materials caused by the bad rate, can reduce plastic, artificial, management, storage, the waste and wastage of material purchase;

Wide application: suitable for pulverizing soft, hard material, such as PU, PVC, PC and ABC.

Simple: easy to open design, easy to change color change, small and small space, suitable for the small workshop stand next to use;

Adopt medium speed motor, low noise, low energy consumption; The motor is equipped with an overload protection device, and has the power chain protection system, which is safe and reliable.

Optional accessories (with double layer stainless steel bucket).

Operating procedures

General provisions

Article 1 reprint machine, grinder drivers must go through the training, to achieve "SanDong" (understand the structure, performance, understand principle), "sihui" (to use, can maintenance, maintenance, troubleshooting), after passing the exam of the training, after obtain certificate of approval, party must mount guard operation.

Article 2 the driver and the driver of the conveyer belt conveyor are closely coordinated with the driver of the working face scraper, and the unified signal is connected in sequence and stopped. In the case of large coal and gangue, it should stop the conveyor operation of the working and face scraper when the feeding port of the mill is overflowed. If the large coal, the gangue cannot enter the broken connection or the metal object, must stop processing.

Preparatory work

1. Tools: wrenches, pliers, screwdrivers, hammers, shovels, etc.

2. Necessary spare parts: all kinds of short chain, link, bolt, nuts, crusher, etc.

3. Lubricating oil and turbine oil

Check processing

1. The connecting parts of motor, reducer, hydraulic coupling, head, tail and other parts must be complete, sound and tight. The reducer and hydraulic shaft section should be free of oil, oil and oil.

2. The signal must be sensitive and reliable, and no signal will be switched on. The spray sprinkler shall be in good condition.

3. The power cable and operating line must be kept in order without extrusion;

4. Coal, gangue, sundries and motor and reducer coal dust near the head of the machine must be cleaned.

5. The end of the working face scraper is suitable for the end of the reprinting machine;

6. The scraper chain plate is very important, and the scraper and screw must be fully fastened.

7. The transfer machine must be stable and reliable;

8. When the machine is turned on in part, the operation of each part shall be no abnormal sound. The scraping plate, chain and connecting ring shall be free of torsion, twist and twist;

9. The roadway support of the grinder and grinder must be in good condition and firm.

10. Safety net and protection device of the pulverizer shall ensure that the deformation is not invalid and safe and reliable;

11. The roadway support of the reloader and the grinder must be in good condition and firm.