Fully Automatic Balers

Pack the material into the tank, the operation of the valve handle, the door closed and the lock will lock the door so that it does not float, the primary preload, and then press the fuel tank forward secondary compression; stroke in place, Main pressure cylinder forward to the final compression, the main pressure cylinder to system pressure after packing 3 to 5 seconds, the main cylinder side return, pull out the lock and open the door, turn the fuel tank turn out the package and return, At this point to complete a work cycle.

Product Details

Fully automatic balers Working principle

Pack the material into the tank, the operation of the valve handle, the door closed and the lock will lock the door so that it does not float, the primary preload, and then press the fuel tank forward secondary compression; stroke in place, Main pressure cylinder forward to the final compression, the main pressure cylinder to system pressure after packing 3 to 5 seconds, the main cylinder side return, pull out the lock and open the door, turn the fuel tank turn out the package and return, At this point to complete a work cycle.

Note: 

The length of the block depends on the weight, material and geometry of the waste material being extruded. Therefore, the relatively thick waste material with high density is not allowed to be loaded too much. Otherwise, the mass will be too long Can not turn over the mass, or even cause side pressure head can not be put in place, causing the main pressure head dislocation and a series of ills.

ptz_01

ptz_02

ptz_03

ptz_04

ptz_09

ptz_06

ptz_07

ptz_10

Inquiry